Breakout Box
The AFMWorkshop Breakout Box is designed for customers that want access to the electronic signals generated in the Ebox. The signals are derived from the 50 pin user port at the rear of the Ebox. Pin assignments from the Ebox are given in the following diagram.
Click to Submit Inquiries or Questions
Description
Model ID: BB-4445
Download datasheet here
| BNC # | Signal | Cable/Breakout Board |
| 1 | X Drive | 3 |
| 2 | Y Drive | 7 |
| 3 | Z Drive | 11 |
| 4 | Z Error | 13 |
| 5 | Z Set | 15 |
| 6 | Z Amp | 19 |
| 7 | Z Phase | 21 |
| 8 | T-B | 28 |
| 9 | Open | |
| 10 | Open |
At the front of the Breakout Box are 10 BNC connectors. As shipped, 8 of these BNC connectors are connected to 8 of the lines from the 50 pin connector. Two of the BNC’s are available for connection to additional lines on the 50 pin connector.
This drawing shows all of the signals found on the 50 pin user connector that is connected to the Breakout Box. It is possible to connect any of the signals from this cable to a BNC at the front of the BreakOut Box.
